bebop 2

[baddad377]

I am new here and to all of this so bare with me. I crashed my bebop 2 drone and now when I try to fly it I cant without calibrating it but it wont calibrate. I hit the calibrate button and it tells me to spin it counterclockwise and I do but it just keeps spinning and nothing happens.can anybody please help me fix this issue?im so ready to get back to flying..please and thank you,johnny

[IronSpear]

G'day mate.

Did you do a hard reset after your crash?

You turn on your drone and wait for it to boot up.
Then press and hold the power button for at least 20 seconds (I think it say only 10 seconds in the manual but I keep it pressed for 20 seconds)
Then you need to wait for it to reset (it takes a while you have to be patient)
Once reset then try the calibration.
Also make sure you have the latest firmware update on the drone, if you have then the calibration process changed a bit with the latest firmware.
You now have to spin the drone a bit faster to get it to calibrate.

Depending on how bad the crash was you may have damaged a part on the main circuit board or damaged a sensor.

Good luck!

[dries_w]

Just make the calibration moves faster, it will calibrate