Login to disable ads!

AR Drone 2.0. 6 pin header Arduino nano

Mirumod, Macgyver, hull, cam, propeller, leg, cross, ball bearing mods... etc.
Post Reply
ag3ntwilson
Newcomer
Posts: 1
Joined: 10 Oct 2019, 07:50
Drone Type: AR.Drone 2
Has thanked: 0
Been thanked: 0

AR Drone 2.0. 6 pin header Arduino nano

Post by ag3ntwilson » 10 Oct 2019, 19:38

Having trouble deciphering the picture on the mirumod page , the wiring diagram has black cables that appear to be shorting 3 pins on the current level switcher.??
And Red cables on left of current switcher that start at 2 pins then lead off into one cable.

And the yellow dots on the Arduino??

Can somebody please clear this diagram up please I am more confused than I probably should be ..

Can somebody use paint or something and draw me an idiot guide please .. thank you 😁🤣

http://mirumod.net/hw/arduino_nano/MIRU ... SGLLC2.jpg

I have:

Parrot AR 2.0 ( 6 pin header)
Arduino nano V3
(Old type) current level switcher
And the transmitter/reciever below....

UNIKEL FlySky FS-i6 2.4G 6CH RC Transmitter With FS-iA6 Receiver for Airplane Heli UAV Multicopter Drone (rc radio transmitter and receiver) https://www.amazon.co.uk/dp/B073H4G43F/ ... NDbPE5T6XS

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests