Motor connector

[mefistotelis]

I have 2 damaged Sumos, one has motors soldered directly to a cable, second has a nice 2-pin connector.

The plan is to make one working Sumo out of these. I really like the connector and would like to use it.

What is the connector model marking?

[mefistotelis]

Oh joy, my post is finally visible. After two days.

This was a mistake.
Question no longer relevant.

[AR.Tommy]

How did you solve it?

[mefistotelis]

I soldered cable with the connector to the end of cable without connector. That increases resistance and inductance of cables, but the change shouldn't be large enough to make the drone unstable.

Also, turns out motors between the two drones were different. So if you're replacing Sumo motors, make sure you replace both. If you only do one, the drone may start spinning regardless of what you're trying to do.

For the connector itself, it's one of these:

Motor connector
Search text: CONN HEADER SMD 2POS 1.2MM
Hirose DF57H-2P-1.2V
Molex 078171-0002
JST BM02B-ACHSS-GAN-TF
TE Conn. AMP Connectors 1909782-1

Motor plug
Search text: CONN RCPT 2POS 1.2MM
Hirose DF57H-2S-1.2C
Molex 078172-0002
TE Conn. AMP Connectors 1909783-1
JST ACHR-02V-K