where to get old firmware for mambo

[cblnetid]

I just recently bought a brand new mambo FPV. I am a developer so my intention is to use it for programming and I am using pyparrot to this end.
I followed the setup instructions and updated the firmware to the last version 3.0.26. However, to my surprise, I found later the following note in the pyparrot documentation:

Note: Parrot broke the ability to access the groundcam in their latest (3.0.25) firmware upgrade. We will reenable these functions as soon as parrot fixes the firmware but for now, they will only work in versions 3.0.24 and below.

So I am looking to downgrade the firmware but cannot find any version in the Internet.

[Dirk_ANAFI]

Hi,

I have versions 2.6.11, 3.0.6, 3.0.17, 3.0.26.
Which do you want?
If you send me an Email address (via PM) I will send you the FW.

[AR.Tommy]

I could host them on the forum server if you like to send them to me.

[Dirk_ANAFI]

Ok!
Send to ****digitalsirup.com ?

[AR.Tommy]

Ok!
Send to ****digitalsirup.com ?

Sent you PM.

[Dronepilot00]

can an older version help my parrot mambo? it flies for 10 seconds then flips and hits the ground. it never done this before, this happen random. engines and props are good. can you email me the older versions. my email is markesoler@mail.com


thanks.

Hi,

I have versions 2.6.11, 3.0.6, 3.0.17, 3.0.26.
Which do you want?
If you send me an Email address (via PM) I will send you the FW.

[Dirk_ANAFI]

No, the newest firmware doesn't make Mambos flip.

[Dirk_ANAFI]

Ok!
Send to ****digitalsirup.com ?

Sent you PM.

I sent it on 04/25. Came back as too large (39 MB).
Now for a week on Dropbox: https://www.dropbox.com/s/zicqaxvopz2ug ... W.zip?dl=0

[AR.Tommy]

Yes of course, that is way too large. We transfer or Dropbox is fine. Downloading it now, thanks. Will soon provide a thread with the links.

[AR.Tommy]

Just saw that you also provided the release notes! Wow that is great. The firmware versions are now available here: viewtopic.php?f=127&t=10120