Bebop 2 booting problem

[Artis]

When I press the start button, the fan turns on for 2 seconds and the light just flashes slowly for unlimited amount of time. The drone doesn't boot up. Where is a problem?

[waterlanding]

When I press the start button, the fan turns on for 2 seconds and the light just flashes slowly for unlimited amount of time. The drone doesn't boot up. Where is a problem?

Try pressing and HOLDING the button for 15 seconds to trigger a full reset. Then wait about 2 minutes as the drone goes through it's reset cycle. You should see the light come on. blink, go off, on, blink, and finally become stable after a couple minutes unless you have a serious hardware problem. Just be sure to give it time for the whole cycle to complete.

[Artis]

When I press the start button, the fan turns on for 2 seconds and the light just flashes slowly for unlimited amount of time. The drone doesn't boot up. Where is a problem?

Try pressing and HOLDING the button for 15 seconds to trigger a full reset. Then wait about 2 minutes as the drone goes through it's reset cycle. You should see the light come on. blink, go off, on, blink, and finally become stable after a couple minutes unless you have a serious hardware problem. Just be sure to give it time for the whole cycle to complete.

After holding the button drone turns off and goes back on and the light just starts blinking again. After like 15 minutes of waiting the light is still blinking.

[waterlanding]

After holding the button drone turns off and goes back on and the light just starts blinking again. After like 15 minutes of waiting the light is still blinking.

Does the drone's wifi show up on your phone? Can you connect to it?
If you can, open Freeflight Pro and click on the drone's name. Scroll down and check for motor errors.

[ferselami]

in this situation drone does not connect to phone and it is not posible to reset in factory seting . these are after normal booting

[waterlanding]

in this situation drone does not connect to phone and it is not posible to reset in factory seting . these are after normal booting

There are a lot of boot failure which will cause the light to blink, and some aren't fatal.
Example: If there's a motor error it will cause the light to blink, but you can still connect.
That's why I suggested "Artis" check and see if his drone has wifi, which could really help to narrow down the problem.

[Artis]

I can't see wi-fi on this stage.

[ferselami]

yes i see bebop wifi on my telephone ! but they are not connet to each others . i changed 4 motores but no any change .
CAn i disconect GPS for testing or after that light continue to flashing ?

[Leedin]

Ok got given a crashed bebop 2 have fixed cross frame fan camera stripped it down put it all back together switch on just it all starts fan then stops beeps 4 times and red light just flashes non stop done reset it restarts but red light just flashes bebop ID comes up on wifi I connect go back to freeflight drones name empty press connect goes to wifi connect to bebop Id comes up connected back to ffp and drone name not there just connect anyone got any ideas

[Andy999]

Hi. Did you find an answer to your problem, this is exactly the same problem as me. Many thanks.

[LoveBebops]

After a soft crash of about twenty feet into a small bush I'm experiencing the same thing with a power edition. When I look at the free flight pro on the tablet ( I use a SC1 black edition) and go into my wi-fi connections and find the bebop and click on it,it still won't connect. It shows gps and batt condition but only for the SC1. Keeps telling me Bebop is not connected.




Jim