Hi, I am new to the drone world. I bought my son a Mambo for xmas and while setting up the FVP camera changed to the WPA2 security. I applied a password but when I try to connect to the Mambo wifi it says incorrect password. I must have put a wrong character in somewhere along the line.
Is there a way to reset the password? I have tried to do a hard reset by holding the power button etc but to no avail.
Thanks, Dean
Login to disable ads!
Incorrect WPA2 Password - Mambo
- AR.Tommy
- Serious flight time
- Posts: 1330
- Joined: 07 Oct 2010, 07:59
- Drone Type: Bebop
- Has thanked: 76 times
- Been thanked: 59 times
Re: Incorrect WPA2 Password - Mambo
Hello and welcome,
okay to perform a factory reset follow these steps:
1. Switch on the mambo and wait for the LEDs to turn green.
2. press the Power button again and keep it pressed for about 30 seconds. During this period:
* The two LEDs turn red alternatively and start blinking.
* The frequency of blinking increases indicating the last stage of the reset process.
* Keep the Power button pressed until the LEDs turn green.
3. You should be able to connect again via bluetooth.
okay to perform a factory reset follow these steps:
1. Switch on the mambo and wait for the LEDs to turn green.
2. press the Power button again and keep it pressed for about 30 seconds. During this period:
* The two LEDs turn red alternatively and start blinking.
* The frequency of blinking increases indicating the last stage of the reset process.
* Keep the Power button pressed until the LEDs turn green.
3. You should be able to connect again via bluetooth.
-
- Newcomer
- Posts: 2
- Joined: 27 Dec 2018, 15:00
- Drone Type: Mambo
- Has thanked: 1 time
- Been thanked: 1 time
Re: Incorrect WPA2 Password - Mambo
Thanks for the reply, I have done several factory resets without success. I have just tried a few more times and now it has cleared. Thanks, son is a happy boy again 

Who is online
Users browsing this forum: No registered users and 1 guest