I was recently given an AR Drone 1.0 without knowing much about it or what condition it was in. I wasn't given the battery or charger so I changed the ESC plug to a Traxxas high current connector to use with a Traxxas 3-cell 1400maH battery.
The drone powers on fine with the Traxxas battery, but I did have some trouble getting it to connect to my device. After resetting several times and messing with the WiFi, I believe I got the correct firmware updated and finally got it to connect to the FreeFlight app. But now I hit Take Off and the motors spin for a moment and then I get an 'Emergency Cutoff' notice. I can't get it to do any more than that.
Without knowing much else about its condition I can only suspect this may be due to the battery change? From what I can tell the AR 1.0 stock battery is a 3-cell and I've seen after-market batteries up to 2500maH so I can't see how over-voltage would be the problem. The drone appears to be OK structurally--gears all in good shape and the motors spin without issue. Has anyone else attempted or had success with using a different battery? Or know any other reasons I could be getting this error?
Problems of AR Drone 1.0, Freeflight 1.
1 post • Page 1 of 1
Users browsing this forum: No registered users and 3 guests