Flight recorder GPS
-
- Newcomer
- Posts: 1
- Joined: 02 Jun 2018, 20:00
- Drone Type: AR.Drone 2
- Has thanked: 0
- Been thanked: 0
Flight recorder GPS
Hi and thanks for reading. I have just bought my new ar.drone 2.0 and a flight recorder GPS. It works on the pc(light flashes). When i connect to drone. It takes a while for the drone to reconise it then the light starts to flash steady. On the app(iphone) i can not see the global in the top right. All is updated and cant find any help regarding this so please if you can spare a little time to five a newbie deone flyer a hand before i give it all up as i dont want to loose my drone again. Thanks
- AR.Tommy
- Serious flight time
- Posts: 1281
- Joined: 07 Oct 2010, 07:59
- Drone Type: Bebop
- Has thanked: 57 times
- Been thanked: 49 times
Re: Flight recorder GPS
Hello,
this may help (I never did this on my own but it's from a thread of the german board)
Try the following to reset the GPS to factory settings:
1) boot into Windows (if you are on something else)
2) install GPS driver (it's on the usb gps flight recorder)
3) install and run SiRF Demo: http://www.falcom.de/support/software-tools/sirf/
4) select source: serial port (usually COM3), baud rate 4800
5) Action > Open Data Source
6) if you don't see any data coming from the device, try Action > Synchronize Protocol & Baud Rate
7) once you verify that it's properly detected, go to Action > Initialize Data Source and perform factory reset.
this may help (I never did this on my own but it's from a thread of the german board)
Try the following to reset the GPS to factory settings:
1) boot into Windows (if you are on something else)
2) install GPS driver (it's on the usb gps flight recorder)
3) install and run SiRF Demo: http://www.falcom.de/support/software-tools/sirf/
4) select source: serial port (usually COM3), baud rate 4800
5) Action > Open Data Source
6) if you don't see any data coming from the device, try Action > Synchronize Protocol & Baud Rate
7) once you verify that it's properly detected, go to Action > Initialize Data Source and perform factory reset.
Who is online
Users browsing this forum: No registered users and 4 guests