Page 1 of 1

(almost) all Bebop 1 and Bebop 2 Motor Error Codes

Posted: 06 Nov 2018, 06:54
by AR.Tommy
Almost all Bebop motor error codes:

Motor Failure Error Code (1), EEPROM access failure
Motor Failure Error Code (2), Motor stalled
Motor Failure Error Code (3), Propeller cutout security triggered
Motor Failure Error Code (4), Communication with motor failed by timeout
Motor Failure Error Code (5), RC emergency stop
Motor Failure Error Code (6), Motor controller scheduler real-time out of bounds
Motor Failure Error Code (7), One or several incorrect values in motor settings
Motor Failure Error Code (8), Battery voltage out of bounds
Motor Failure Error Code (9), Incorrect number of LIPO cells
Motor Failure Error Code (10), defect MOSFET or broken motor phases
Motor Failure Error Code (11), too hot or too cold cypress temperature

Re: (almost) all Bebop 1 and Bebop 2 Motor Error Codes

Posted: 06 Nov 2018, 17:43
by asmith61
Hi Ar.tommy

Thank you for this information I will keep this safe for future reference :D

Re: (almost) all Bebop 1 and Bebop 2 Motor Error Codes

Posted: 04 Dec 2018, 14:36
by mahodder
"Motor Failure Error Code (11), too hot or too cold cypress temperature"

What does this mean?

Re: (almost) all Bebop 1 and Bebop 2 Motor Error Codes

Posted: 04 Dec 2018, 14:42
by AR.Tommy
This means the motor is either too cold or too hot. (Or the sensor is broken)

Re: (almost) all Bebop 1 and Bebop 2 Motor Error Codes

Posted: 04 Dec 2018, 16:37
by mahodder
Weird, I'm getting a Motor 11 error now on a back motor on my Bebop 2 and I've replaced the motor and did a full drone reset but it's still giving me that same error.

The sensor is on the mainboard and each motor has their own I wonder?

I haven't done a complete disassemble yet - I guess that is my next step to see what's up. :geek:

Re: (almost) all Bebop 1 and Bebop 2 Motor Error Codes

Posted: 04 Dec 2018, 16:44
by AR.Tommy
Personally I had this error only once and a simple reboot of the Bebop fixed it. Are you sure you did the reset correctly?

Re: (almost) all Bebop 1 and Bebop 2 Motor Error Codes

Posted: 04 Dec 2018, 16:53
by mahodder
All my wifi settings and everything was wiped but I'll try again before taking it apart to make sure.

Re: (almost) all Bebop 1 and Bebop 2 Motor Error Codes

Posted: 28 May 2019, 13:22
by deadhead69
mahodder wrote:
04 Dec 2018, 16:37
Weird, I'm getting a Motor 11 error now on a back motor on my Bebop 2 and I've replaced the motor and did a full drone reset but it's still giving me that same error.

The sensor is on the mainboard and each motor has their own I wonder?

I haven't done a complete disassemble yet - I guess that is my next step to see what's up. :geek:
I had a crash landing with my Beebop 2 and now the LEFT rear motor is getting an ERROR CODE 11. Is this sort of damage/issue/thing covered under the warranty? I've only had the Beebop2 since Christmas 2018