Communication with motor failed by timeout

Questions and answers about Bebop, Bebop 2 and the Parrot Skycontroller.
Post Reply
User avatar
ym58
Newcomer
Posts: 3
Joined: 28 Mar 2017, 15:13
Drone Type: Bebop 2

Communication with motor failed by timeout

Post by ym58 » 28 Mar 2017, 15:25

Hello,Communication with motor failed by timeout

I am trying to troubleshoot a Bebop2 motherboard.

After typing the following Telnet command :
BLDC_Test_Bench_S
the 4 (four) motors (without the blades, of course) will all start spinning, then abruptly stop after 3 seconds.

Then, after checking the failure reason ( with BLDC_Test_Bench_I ), I receive the following message :
Version is: '5.1.R.4'
Previous flight time : 3 seconds
Last error : 'Communication with motor failed by timeout'


Any clue ?
Thanks !

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests