Hello,Communication with motor failed by timeout
I am trying to troubleshoot a Bebop2 motherboard.
After typing the following Telnet command :
the 4 (four) motors (without the blades, of course) will all start spinning, then abruptly stop after 3 seconds.
Then, after checking the failure reason ( with BLDC_Test_Bench_I ), I receive the following message :
Version is: '5.1.R.4'
Previous flight time : 3 seconds
Last error : 'Communication with motor failed by timeout'
Any clue ?
Questions and answers about Bebop, Bebop 2 and the Parrot Skycontroller.
1 post • Page 1 of 1
Users browsing this forum: No registered users and 2 guests