Login to disable ads!


Questions and answers about Bebop, Bebop 2 and the Parrot Skycontroller.
Post Reply
Battery Charged
Posts: 7
Joined: 21 Aug 2020, 16:58
Drone Type: Bebop 2
Location: USA Connecticut
Has thanked: 0
Been thanked: 0


Post by LoveBebops » 10 Sep 2020, 20:04

I just installed a new mother board on my power edition. I've replaced a couple over the years,it's not that difficult just time consuming. Anyway,it booted up and connected to the SC1 easily but had no camera or gps. I took the camera/gps mount off to double check connections. When I went to boot up again it wouldn't power up. So i took the camera mount off again and it booted up again. I reinstalled the camera/gps and again it wouldn't power up. The battery is locking in place like it should. Now even with the camera/gps off and unplugged when powering up it acts like the old mother board..the fan runs for a few seconds then shuts off and it wont connect to the SC1 I'm thinking of shooting it with my 357 :oops:

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests