Mirumod, Macgyver, hull, cam, propeller, leg, cross, ball bearing mods... etc.
3 posts • Page 1 of 1
- Ready for take off
- Posts: 16
- Joined: 18 Aug 2013, 02:04
- Drone Type: AR.Drone 2
- Location: San Diego CA
- Has thanked: 0
- Been thanked: 0
Had a Parrot cross with a broken foot, so I cut it off clean, and added this 3D printed part with a zip-tie.........nice, clean and simple.....haven't flown with it yet, but should work just fine.....
If you feel like experimenting, my 3D printed pieces can be found here:
Users browsing this forum: No registered users and 9 guests