Having trouble deciphering the picture on the mirumod page , the wiring diagram has black cables that appear to be shorting 3 pins on the current level switcher.??
And Red cables on left of current switcher that start at 2 pins then lead off into one cable.
And the yellow dots on the Arduino??
Can somebody please clear this diagram up please I am more confused than I probably should be ..
Can somebody use paint or something and draw me an idiot guide please .. thank you
http://mirumod.net/hw/arduino_nano/MIRU ... SGLLC2.jpg
Parrot AR 2.0 ( 6 pin header)
Arduino nano V3
(Old type) current level switcher
And the transmitter/reciever below....
UNIKEL FlySky FS-i6 2.4G 6CH RC Transmitter With FS-iA6 Receiver for Airplane Heli UAV Multicopter Drone (rc radio transmitter and receiver) https://www.amazon.co.uk/dp/B073H4G43F/ ... NDbPE5T6XS
Login to disable ads!
Mirumod, Macgyver, hull, cam, propeller, leg, cross, ball bearing mods... etc.
1 post • Page 1 of 1
Users browsing this forum: No registered users and 11 guests