Page 1 of 1

Incorrect WPA2 Password - Mambo

Posted: 27 Dec 2018, 15:09
by DeanoDude
Hi, I am new to the drone world. I bought my son a Mambo for xmas and while setting up the FVP camera changed to the WPA2 security. I applied a password but when I try to connect to the Mambo wifi it says incorrect password. I must have put a wrong character in somewhere along the line.

Is there a way to reset the password? I have tried to do a hard reset by holding the power button etc but to no avail.

Thanks, Dean

Re: Incorrect WPA2 Password - Mambo

Posted: 27 Dec 2018, 15:53
by AR.Tommy
Hello and welcome,

okay to perform a factory reset follow these steps:

1. Switch on the mambo and wait for the LEDs to turn green.

2. press the Power button again and keep it pressed for about 30 seconds. During this period:
* The two LEDs turn red alternatively and start blinking.
* The frequency of blinking increases indicating the last stage of the reset process.
* Keep the Power button pressed until the LEDs turn green.

3. You should be able to connect again via bluetooth.

Re: Incorrect WPA2 Password - Mambo

Posted: 27 Dec 2018, 16:55
by DeanoDude
Thanks for the reply, I have done several factory resets without success. I have just tried a few more times and now it has cleared. Thanks, son is a happy boy again :)