hi I'm new to this, can anyone tell me where I can get hold of a main mother board for the upair one. I crashed it and the gimbal came off. this pulled the wires out of the connector on the gimbal. its a 6 wire lead 3 red 3 black. I have taken the drone apart to see what order they go in at the mother board end. I have put them back in the gimbal end connector the same as mother board end but when I started it up I got a burning smell. I turned off straight away and took the drone apart. what I found was a burnt out part on the mother board. any help would be most greatfull
Other discussion of non-Parrot drones. 3drobotics, DJI, Team Black Sheep, QAV250, DIY drones... etc.
1 post • Page 1 of 1
Users browsing this forum: No registered users and 14 guests