brass bearing removal and ball bearing install?

Mirumod, Macgyver, hull, cam, propeller, leg, cross, ball bearing mods... etc.
Post Reply
360Rocket
Just flips over
Posts: 90
Joined: 15 Feb 2013, 02:35
Drone Type: AR.Drone 2

brass bearing removal and ball bearing install?

Post by 360Rocket » 05 Mar 2013, 04:05

whats the easiest and safest way to remove the brass bushings and install the boca bearings?

thanks gang.

User avatar
DBS
I've been hit!!
Posts: 2764
Joined: 15 May 2012, 16:27
Drone Type: DISCO
Location: Treasure Coast, Florida
Contact:

Re: brass bearing removal and ball bearing install?

Post by DBS » 05 Mar 2013, 04:20

Use an old shaft to insert into the old bushings and rock back and forth while pulling and they will come out...

Just use your fingers and squeeze the new bearings into place the top one is harder than the bottom one for some reason

This dude shows the bushing pull at time stamp 1:40

Direct link: http://www.youtube.com/v/RIGFkLlJDcY
WORLD RECORD Phantom 4 flight CLICK HERE
WORLD RECORD Matrice 600 flight CLICK HERE

360Rocket
Just flips over
Posts: 90
Joined: 15 Feb 2013, 02:35
Drone Type: AR.Drone 2

Re: brass bearing removal and ball bearing install?

Post by 360Rocket » 05 Mar 2013, 13:40

Ha ha, Just found that very same video. It has gone smoothly but now the 4 torx screws on the mother board wont come out? Ive turned and turned and turned and they just wont come out?

Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests