Question on bottom camera

Mirumod, Macgyver, hull, cam, propeller, leg, cross, ball bearing mods... etc.
Post Reply
oldjarhead46
Up and hovering
Posts: 103
Joined: 12 Sep 2013, 17:31
Drone Type: AR.Drone 2
Location: Midwest US
Has thanked: 0
Been thanked: 0

Question on bottom camera

Post by oldjarhead46 » 20 Jun 2016, 18:24

Hi,
I have made a body out of fiberglass. My question is the lower camera is mounted on a fiberglass strut and now has a pattern that's shown in pic all the time. It still shows bottom view but pattern is also in pic. Any suggestions?
image.png
You do not have the required permissions to view the files attached to this post.

User avatar
garrock
I've been hit!!
Posts: 2089
Joined: 01 Sep 2012, 16:14
Drone Type: AR.Drone 2
Location: USA - Portsmouth, Ohio
Has thanked: 0
Been thanked: 0

Re: Question on bottom camera

Post by garrock » 11 Aug 2016, 23:09

oldjarhead46 wrote:Hi,
Any suggestions?
image.png
It appears something is in the way of the bottom looking camera image.

The image must not be obstructed or else the drone will be confused and not be able to hover lock into position.
DroneMod.com --- Worlds first two-drone system: Repeater-Helper and Camera-Worker drones ! --- http://www.REDbirdRF.com

oldjarhead46
Up and hovering
Posts: 103
Joined: 12 Sep 2013, 17:31
Drone Type: AR.Drone 2
Location: Midwest US
Has thanked: 0
Been thanked: 0

Re: Question on bottom camera

Post by oldjarhead46 » 26 Aug 2016, 01:24

Sorry it took so long to reply . There was nothing in the way. The camera was mounted on a fiberglass strut out in the open. This was on a fiberglass panel
Similar to the RC drone kits. But it doesn't
Matter now as it flew away.

Post Reply

Who is online

Users browsing this forum: No registered users and 171 guests